- Additional information
In the standard BALERT and BALERT-W break beam sensor entry alert kit, the product ships with a mounting bracket that you would use to mount the sensor on a door frame. Sometimes you might want to mount the sensor directly on the wall and the included bracket isn’t the best fit. The BALERT-WM is a wall mounting bracket that allows you to mount the sensor directly up against the wall.
The wall mount includes 1 x wall bracket, 3 x sheet metal screws, and 3 x screws to mount the sensor to the bracket
|Kit Or Accessory|
Customer ReviewsWrite a review
Product arrived quickly and was a fairly easy installation. Works great so far.
One thing I'd like to add is to have the ability to cant the reflector to allow for a diagonal beam.
Otherwise I would recommend this product and order it again.
Every thing was a great experience..thank you
Our store (in a shopping mall) had a little battery powered motion sensor that would be set off by people walking up the steps 20 feet away. It was a constant annoyance that would as often as not go off when nobody was there, but be silent when people walked in.
The BALERT Photo Beam Reflector Kit was easy to install - I skipped the mounting plates (tile walls) and used velcro adhesive strips, set it up in under 5 minutes, and it works perfectly!
My only regret - not getting the add-on speaker to run a line to the back room. But we're adding that ASAP!
It was exactly what we were looking for! Easy to install and works great!
The Entry Detector works great. We needed a entry detector to help keep our cats and dog out of one room. This entry detector work perfectly for us. We tried a cheaper brand from Amazon. I ignored some of the negative review and the warnings in their review. That device worked OK, not great, sometimes didn't pick up the cats. It died after 60 days. This Entry Alarm is much simpler and easier to install. The cable is a way to long for our use, but would like it too long than not long enough.