Mounting the ERA-UTX

This document does not discuss programming the ERA-UTX but rather the physical mounting of the transmitter. You do not need the smaller magnetic if using a push button only.

Mounting the ERA-UTX as a Push Button

You can use the transmitter as a doorbell that activates when the center button is pressed.

• Use a drill bit and two of the two included screws to mount the transmitter bracket. Make sure the arrow printed on the bracket is pointed up.
• If mounting outside, ensure the grey silicon grommets covering the screw holes are inserted.

• Slide the transmitter down onto the bracket.

Mounting the ERA-UTX as a Door/Window Contact

The ERA-UTX may also be used as a magnetic door/window contact that triggers when the smaller magnet separates from the larger piece.

• Choose mounting locations where the magnetic contact (the smaller piece) is 1/2 inch or less from the push button (the large piece).

• Mount the magnetic contact with a drill and the two included screws, then snap the cover back on the magnet.

• Mount the transmitter bracket with the drill holes and two included screws. Make sure the arrow on the bracket is facing up.

• If you mount your transmitter outdoors, ensure the silicon grommets are plugged into the push button (the larger piece) to waterproof the casing.
• Slide the transmitter down onto the bracket.