Skip to main content
800-366-7235
Since 1998
BSCOL-AP ionic column design lighted Wired doorbell button
Product manual

BSCOL User Manual

Setup, pairing, and troubleshooting for the BSCOL Craftmade Classic Styled Ionic Column LED Doorbell Button.

  • TEIBER LIGHTING PRODUCTS
  • A Member Of The
  • Craftmade Family Of Products
  • Craftmade
  • TWO NOTE DOOR CHIME
  • READ AND SAVE THESE INSTRUCTIONS

WIRING

TURN OFF POWER AT BREAKER BOX BEFORE WIRING THIS CHIME.

ALL ELECTRICAL WORK MUST BE DONE IN ACCORDANCE WITH LOCAL AND/OR NATIONAL ELECTRICAL CODE AS APPLICABLE.

CHIME MECHANISM F T R REAR DOOR (IF INCLUDED) FRONT DOOR 120 VAC LINE IN GROUND 16 VAC TRANSFORMER DO NOT MOUNT TRANSFORMER WHERE TEMPERATURE WILL EXCEED 125° F.

INSTALLATION

TURN OFF POWER AT BREAKER BOX BEFORE INSTALLING, WIRING, OR SERVICING THIS PRODUCT.

  1. Bring wiring through access hole in chime mechanism.
  2. Attach chime mechanism to wall with screws provided.
  3. Connect wires to correct terminals as shown in wiring diagram.
  4. Turn on power. Make sure push buttons operate door chime properly. (Two notes for front door, one note for second door)
  5. Must use hanging bracket installed in chime cover to mount this chime cover. Do not hang cover onto chime mechanism base due to its weight.
  6. Mount the transformer to a rafter or junction box as shown in Fig. A.

SCREW MTG. Fig. A TO CHIME AND PUSHBUTTON 120V AC WIRING

TEIBER LIGHTING PRODUCTS

ONE YEAR LIMITED WARRANTY TERM: One year from date of purchase of the original consumer.

COVERAGE: Products will be free from defects in materials or workmanship. There are no other warranties, express or implied, including, but not limited to, implied warranties of merchantability or fitness for a particular purpose. Not covered: Normal maintenance and service, products subject to misuse, neglect, accident, improper maintenance or service, or installation differing from the recommended installation instructions.

REMEDY: Teiber Lighting Products will repair or replace, at its option, without change, any product or part, which is found to be defective under normal use. This is the sole remedy under this warranty. Teiber Lighting Products will not be liable for secondary, consequential or special damages arising out of or in connection with product use or performance.

This warranty gives you specific legal rights, and you may have other rights, which vary by state. This warranty supersedes all prior warranties.

To qualify for warranty services, please contact Teiber Lighting Products with the following information: model number, evidence of original purchase date and nature of defect.

TEIBER LIGHTING PRODUCTS www.teiber.com (1-800-486-1892)

May 2006

One Door Chime

120 Volt AC Transformer Ground 16 volt 10 va Do not oil Rear Trans Front Rear or Side Door Button Front Door Button Note: Some chime mechanisms have a terminal marked "0 Batt". This is not to be used with a transformer.

Two Door Chimes

120 Volt AC Transformer Ground 16 volt 15 va or 16 volt 30 va Do not oil Rear Trans Front Rear or Side Door Button Front Door Button Do not oil Rear Trans Front Note: Some chime mechanisms have a terminal marked "0 Batt". This is not to be used with a transformer. May 2006

Three Door Chimes

120 Volt AC Transformer Ground 16 volt 10 va

Do not oil Rear Trans Front

Do not oil Rear Trans Front

Do not oil Rear Trans Front

Rear or Side Door Button

Front Door Button

Note: Some chime mechanisms have a terminal marked "0 Batt". This is not to be used with a transformer.

Questions?

Visit www.teiber.com or call Teiber Technical Support at 1-800-486-4892

ONE YEAR LIMITED WARRANTY

TERM: One year from date of purchase of the original consumer.

COVERAGE: Products will be free from defects in materials or workmanship. There are no other warranties, express or implied, including, but not limited to, implied warranties of merchantability or fitness for a particular purpose. Not covered: Normal maintenance and service, products subject to misuse, neglect, accident, improper maintenance or service, or installation differing from the recommended installation instructions.

REMEDY: Teiber Lighting Products will repair or replace, at its option, without charge, any product or part, which is found to be defective under normal use. This is the sole remedy under this warranty. Teiber Lighting Products will not be liable for secondary, consequential or special damages arising out of or in connection with product use or performance.

This warranty gives you specific legal rights, and you may have other rights, which vary by state. This warranty supersedes all prior warranties.

To qualify for warranty service, please contact Teiber Lighting Products with the following information: model number, evidence of original purchase date and nature of defect.

TEIBER LIGHTING PRODUCTS www.teiber.com

May 2006

This page reproduces the English portion of the printed manual. For the original layout and diagrams, download the PDF above.

Still stuck? Browse the FAQ or contact support.