BL700-SERIES User Manual

DO NOT PRINT GREEN 375 DIE LINES. DIE LINES ARE FOR DIE CUTTING ONLY!

• Remove mounting plate by sliding down and lifting out of keyholes
• Remove battery cover by pressing up on tab and lifting out
• Insert 3 C alkaline batteries (not included).
• Note: be sure batteries are orientated properly. Markings for +/- are engraved in the battery compartment.
• Estimated battery life of 1 year running 12 hours a night on alkaline batteries with up to 14 triggers per night in low light level setting.

• Adjust time and light level if desired.
• Install mounting plate in desired location using screws.
• Install front cover by lining up keyholes and sliding unit down.
• Insure top of mounting plate slides into slot at the top of the unit for a secure fit.
• Install locking screw (included) through the bottom of the unit into the mounting surface to prevent removal.

• Motion Coverage – 30' by 160 degrees
• "Low-Glow" accent light runs dusk to dawn
• Two brightness settings when motion is detected – Hi level for walkways and entry areas – Low level for outdoor living areas
• Time Settings - – Long – 5 min for living areas – Short – 30 sec for walkways

• Xodus Innovations, LLC
• 2025 Yore Avenue
• Benton Harbor, MI 49022

www.xodusinnovations.com

Made in China

Locking Screw

• Model # BL775
• 1 year limited warranty
• Patent # 6,992,591
• Additional patents pending

(Figure 1)