How To Change The Privacy Codes on Carlon Wireless Chime DevicesJason
Changing the privacy codes of a Carlon Wireless Door Chime is a super easy. All you need are a set of the Carlon doorbell instructions, or the Carlon plug-in chime manual and voila– you have an efficient way of preventing outside interference from other devices operating on the same frequency.
And while this is the most common reason someone would want to change the privacy code, there’s another important reason, too. Let’s say you live in a duplex and you, as the landlord, have purchased two Carlon RC3250 wireless doorbell chime kits. You would want to set each unit’s push-button, with its respective receiver, to the same privacy codes. That way, they are not setting each other off.
The whole process can be done in under five minutes and you don’t even need to locate your Carlon doorbell manual– you just need a set of everyday tools you find around your home such as a small screwdriver and a pair of nail clippers and a few minutes to watch the video below. Keep in mind, though, that the privacy code you select must be uniform for both the push button and the receiver. Once these codes have been selected and snipped, there is no un-snipping the wire; that is the code for the device. By default, the push button and receiver come with no code set.
Video Transcription: Changing Carlon Privacy Codes
“Hey, this is Michael with 1800Doorbell.com a Lord Henry Enterprises Company. And what you see in front of me is the RC3250 Wireless Door Chime Kit from Carlon. And what we’re going to discuss in this video are privacy codes. And essentially, what privacy codes do are enable you to change the wireless operating frequency of the product. If you’re getting interference from other devices, or lets say you have a series of push buttons and receivers in your home or office, and you want to isolate certain ones within themselves you would change the privacy codes.
So we have the two pieces of the RC3250 kit: the RC3301, and then here is the RC3253 which is the receiver. So first we’re going to look at the transmitter or the push button. You’ll notice there is a small hole on the bottom of this. Simply take a little screwdriver and push that in and the plate pop off. And what you will notice are a series of little circular wires on the back. There is 1,2,3,4 and 5 on this particular product line from Carlon. And on the back of the receiver, there is a little door here with a screw.
What I am going to do is unscrew this and then pop off the door. And what were going to see are some corresponding wires in the same number as these. Changing the privacy code is as easy as taking something like fingernail clippers and snipping wires on the transmitter– as long as you also snip the corresponding wires on the receiver. So as an example, if I snip wire 1 and 5 on the transmitter, I need to snip the same wire 1 and 5 on the receiver. That is going to ensure that both of these products are operating in the same exact wireless frequency.
If you have a series of products in your home or office and you want make sure they’re only communicating with themselves, then you would just match these privacy codes with one another. By default, these wires are not snipped and obviously once you snip the wires, you can’t go back. If you accidentally snip a wire on the push button, you will need to snip that same wire or combination of wires on the receiver as well. This is going to prevent neighboring push buttons from interfering with your system and any other devices that could happen to be operating on the same frequency.
This was a quick video, so please give us a call at 1-800-366-7235 or email us at firstname.lastname@example.org and we would be happy to give you some help on this product or any other product line. Most of them operate on the same premise its just how you get to these little wires or dip switches is a little different depending on the product line. Thanks and have a great day!”